The United States ASTMF2933 13 new safety standards for baby bed mattress
In May 2013, the United States for testing materials (ASTMInternational), international association is called before the American society of testing materials (AmericanSocietyforTestingandMaterials (ASTM)), announced the new safety standards for baby bed mattress. New standard called "ASTMF2933-13" and provide security and baby bed mattress label requirements.
Introduction to the
The safety standards established a full-size baby bed mattress and the general requirements of the full-size baby bed mattress and label requirements. According to the standard within the scope of the definition, the mattress is a thick cotton fill elastic material, is proposed to be used for or promotion on it for sleep, can be used alone or combined with other products.
The baby bed mattress safety standards set for the following requirements:
General requirements
, baby bed mattress must comply with federal safety standards (that is, the consumer product safety improvement act (CPSIA), "16 cfr1632/1633", etc.)
, there is no risk of sharp point or edge
Small parts, not the choking hazard
, any paint or surface coatings must comply with the 16 cfr1303
, hard material not bring dangerous task of finger
Permanent warning label requirements
, the choking hazard warning label doesn't make the small parts
The mattress size,
Logo and label requirements
All baby bed mattress must conform to the requirements of the warning statement to specify.
